Partial Heat Recovery System. The partial heat recovery exchanger is installed before the main condenser. The system is not regulated and the control is ON-OFF type. The heat recovery system’s operation is subject to the supply and demand water chiller of cooling capacity.
The system includes:
- Copper brazed plate type heat exchanger with cover plates, plates and connections in stainless steel.
- Anti condensate insulation made of polyurethane.
- Upon request voltage free contact slot for partial heat recovery water pump activation. The water pump is not supplied.
The heating capacity which is supplied depends on the kind of refrigerant gas which is used and working temperatures.
The heat exchangers can produce hot water up to the maximum temperature of 70-75 °C and according to the working conditions of the unit.
Total Heat Recovery System. The total heat recovery exchange is installed in parallel to the main condenser. The system is totally controlled by the microprocessor and the control is ON-OFF type. The heat recovery system’s operation is subject to the supply demand of cooling capacity.
The system includes:
- Copper brazed plate type heat exchanger with cover plates, plates and connections in stainless steel.
- Anti condensate insulation made of polyurethane.
- Water temperature probe on heat reclaim water inlet.
- Diverter valve.
- Non return valve.
- Liquid receiver safety valve.
- Hydraulic connections with grooved end. Flexible joint not supplied (optional accessory).
- On request voltage free contact for partial heat recovery water pump activation. The water pump is not supplied.
- On request selector switch for operation mode enabling : “ON, OFF, REMOTE”.